Navidad
Pedir antes del dic. 16  -  Más detalles
×
Menú
Atrás |

Circle Mat Stomp

(3)
Zoom
1 pieza
Cantidad
1 pieza
2 piezas
3 piezas
4 piezas
5 piezas
6 piezas
Limited quantity available
Cantidad
1 pieza
2 piezas
3 piezas
4 piezas
5 piezas
6 piezas
7 piezas
8 piezas
9 piezas
10+
Cantidad
1 pieza
2 piezas
3 piezas
4 piezas
5 piezas
Limited quantity available
Cantidad
1 pieza
2 piezas
Limited quantity available
Cantidad
1 pieza
2 piezas
3 piezas
4 piezas
5 piezas
Limited quantity available
Cantidad
1 pieza
2 piezas
3 piezas
4 piezas
Limited quantity available
Añadir a la cesta
  Guardar para luego
Envío gratuito a partir de $199
Entrega 1-7 días laborables
365 días para la devolución
Navidad
Descripción

An accessory you install between your bindings on the snowboard, so your back foot does not slip.

This stomp is made from molded urethane. Therefor it is light weight and easy to work with.

For optimum bonding, make sure that both board and stomp are at room temperature, clean all surfaces with rubbing alcohol. When ready - Heat up the the prepared board surface with a hair dryer on the highest setting, along with the adhesive on the stomp. Immediately after heating - Place the stomp and press it down firmly. Stand on it without twisting about - The more weight the better. Allow the bond to cure at room temperature for 24 hours.

De la misma marca
Reseñas   (3)
The stomp pad was perfect for my sons board.. the stickers you sent with it were accidentally ruined by the spikes on the pad
Mike McCulloch (Kamloops)
02/16/2021
Evaluación: 5 de 5!
Mostrar todas las 3 reseñas
SkatePro
Privacidad Cookies Condiciones generales